|
    
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[10]
[11]
[12]
[13]
[14]
[15]
[16]
[17]
[18]
[19]
[20]
[21]
[22]
[23]
[24]
[25]
[26]
[27]
[28]
[29]
[30]
[31]
[32]
[33]
[34]
|
So now that the subwoofer enclosure/amp rack is fully assembled, its time to finally get it in the Tundra!
Did I mention it is really heavy? Took three of us to safely carry it The large rear seat was removed and in it goes. But when I get the seat back in - it doesn't fit!!!! The whole thing is sitting two inches too far forward and the overhang from the amplifiers won't allow the seat to to lock into place! If there was a time to panic during this project - this is it!
The entire fit is off. Both sides are out of place:
Closer inspection shows the rail for the seat is in the way:
During the entire design and build, the seat and the sub box were never both in the truck at the same time so I hadn't noticed this Out it comes and the "leg" of the sub box is modified to clear the bracket:
Back in it goes and - whew - it fits like it was made to:
| ||||
You can see how the rail is holding it an inch to the right. Since this was formed to the back wall, an inch throws the entire fit off by a lot.
