|
    
[1] [2] [3] [4] [5] [6] [7] [8] [9] [10] | Next, the four holes for the 80mm intakes in the left side panel.
The fans are installed and it is time to put the case back together. Since there will never be a need to remove the right side (and top) again, I pop riveted it to the chasis.
Need a way to fasten the top front of the left panel down so I put in a nut rivet. This is similar to a pop rivet but leaves a threaded 10-32 hole.
Here is the empty, assembled case. As you can see, I put dust filters over the intakes this time.
| ||||
